ENGINEER 1C03 Study Guide - Final Guide: Axonometric Projection, Solid Edge, Parallel Projection

• School: McMaster University
• Department: Engineering (General)
• Course: ENGINEER 1C03
• Professor: N A

Document Summary

Implementation, evaluation, iteration communicate ideas (most designs are then formally recorded in cad) Less may appear when they are coincident (i. e. the cube: does not work out for a sphere, as a result, limiting elements are drawn to show the extent of curved faces in a view. The previously stated rule is amended to include limiting elements: isometric pictorials and multiviews: both are types of parallel projection but differ in the intended effect of the representation. If interior detail cannot be easily understood in the standard views, then a section should be used: partial and enlarged views: to add clarity or detail to the information regarding a portion of the object. Normally used when a full view would not provide more detail. Sheet sizes, line types, projection, and dimensioning are the same. ; can more easily derive information about the part and assembly (surface area, volume, interference, etc)