CS100 Study Guide - Final Guide: Cable Modem, Electromagnet, Radiography

73 views2 pages

lilacmouse857

6 Jun 2018

School

University of Waterloo

Department

Computer Science

Course

CS100

Professor

Barbara Butler

For unlimited access to Study Guides, a Grade+ subscription is required.

Analogy: devices are like people at a dinner party  everyone speaking  stop and wait for other

people to speak.

 Very specific Protocol in place in order for the conversation to happen.

 If one device/cable is slower, it can slow the entire communication chain.

Unlock document

This preview shows half of the first page of the document.
Unlock all 2 pages and 3 million more documents.

Already have an account? Log in

Document Summary

Analogy: devices are like people at a dinner party everyone speaking stop and wait for other people to speak. Very specific protocol in place in order for the conversation to happen. If one device/cable is slower, it can slow the entire communication chain. Only 2 devices can happen unlike ethernet with multiple devices. Designed for download speed much higher than upload speed. Many of us use a cable modem to connect to the internet. Difference between cable modem and the rest is it communicates over frequencies designed to transmit television signals instead of voice. Conclusion: the above devices are all designed to communicate from one point- one computer to another one such as a head office e. g. rogers. Most common form of electromagnet radiation is visible light. The electromagnetic spectrum is way wider than the colours we see. Red light transmits at a lower frequency than blue light and we interpret it as colours.

Related Questions

Grade 9 Science – Lab Safety & Equipment Woksheet

Part A: Highlight ‘T’ for TRUE OR ‘F’ for FALSE for each of the following questions. (K - 35)

1. T F Broken glassware should be swept up immediately and placed in the garbage bin.
2. T F Eyeglasses or contact lenses are an acceptable substitute for googles during an experiment.
3. T F If you arrive at class to find a spilled liquid on your desk, you should assume it is water and wipe
it up with paper towels.
4. T F Students with long hair must tie it back when using Bunsen burners.
5. T F If you take too much of the chemicals needed for an experiment, put it back into the container you
got it from.
6. T F Class B fires are those related to electrical equipment.
7. T F Discard all solid waste by rinsing it down the sink.
8. T F You may consume food and drinks during a lab, as long as it is kept at a safe distance from
chemicals.
9. T F If asked to detect the odour of a chemical in the lab, the student should inhale a deep breath of the
chemical.
10. T F If your clothing were to catch on fire, your first step should be to STOP, DROP and ROLL.
11. T F When using a fire extinguisher, aim at the top of the fire. The chemical in the extinguisher will
fall and put out the flames.
12. T F When heating chemicals in a test tube, heat from the bottom up, aiming the test tube at the
ceiling, and keep the test tube still.
13. T F It is ok to take off my safety goggles if it’s just for a second while I write something down.
14. T F If any chemical makes contact with your eye, wash it immediately at the eyewash station for
fifteen minutes. If you should spill chemicals on your skin, place the affected area under water
immediately.
15. T F Always read through each activity before you begin.
16. T F If you are unsure about any part of the procedure for an experiment, you should figure it out
yourself. Asking the teacher for clarification will result in a lower mark due to lack of preparation.
17. T F It is acceptable to sit during very long experiments.
18. T F It is ok if I don’t know where the lab safety equipment is since I can just ask someone later.
19. T F Be sure to tell your teacher about any accident, broken equipment, or injury that occurs during
class; no matter how minor.
20. T F When working with chemicals, keep pens and pencils away from your mouth.
21. T F In warmer months, it is acceptable to wear sandals during an experiment.
22. T F Determine whether your equipment is cool enough to disassemble by placing the back of your
hand near it.
23. T F Loose-fitting, long-sleeved shirts should be worn during experiments to protect your arms from
burns and chemical splashes.
24. T F If you must retrieve materials during a lab, it is acceptable to leave your Bunsen burner unattended
as long as it is set to a yellow flame.
25. T F To avoid an injury when heating materials, always place a stopper or tight-fitting lid on the
container being heated.
26. T F If a student uses the last of the chemicals in an experiment, it is their responsibility to go into the
storeroom to retrieve an additional quantity of that chemical.
27. T F Always leave your work area clean and dry before leaving the lab and make sure equipment and
glassware is returned clean to its proper place.
28. T F Horseplay is O.K. during a lab as long as no one is getting hurt.
29. T F It is never advisable to place a thermometer in an open flame.
30. T F To cool hot glassware, run cold water over it.
31. T F Class A fires can be extinguished with water.
32. T F Class D fires must be extinguished with water.
33. T F Keep equipment away from the edge of the lab bench.
34. T F If your eye itches while you are working with chemicals, you should rub it with your hands.
35. T F WHMIS stands for warning hazardous materials information symbols.

jhonny

Hi. You should write a Java program to meet the specification shown below.

In this game(dice poker), the computer rolls two standard six-sided dice and you bet on the outcome. The outcome is the configuration of the numbers rolled (explanation below). The input/output should utilise a graphical user interface (input and message boxes).

1.1 Game flow

You start with some money in your bank. You play a number of rounds, where for each round you place a bet and the computer rolls the dice, checks results and modifies your bank balance. After certain conditions, the game ends and you're presented with some final information shown as a message box.

1.2 Placing bets

Before the computer rolls the dice, you can bet some money from your bank.

ˆ If the numbers are sequential (e.g. 1 and 2, 5 and 4, etc. Not 6 and 1), you earn double your bet.

ˆ If the numbers are identical (rolling doubles), you earn triple your bet.

ˆ Otherwise, you win nothing therefore you lose the amount of money you bet.

Before placing a bet, the computer should inform you of your current bank balance.

1.3 Starting Game- Game rules

When the game starts you are given £6 in your bank. Each bet costs £1 and you are allowed to make up to five bets before the game ends. The game will end if you run out of money, or you have no more attempts left (you made all five bets). At the end of the game, you will be told which of these conditions has ended the game.

1.4 Results display

Once the game has finished (all bets have been placed or you ran out of money) the computer will collate and display the results in a single message box, comprised by:

ˆ On row per bet, displaying your bet, the numbers rolled, the amount of money earned or lost for that bet.

ˆ One row at the end, displaying the amount of money that you have remaining in your bank at the end of the game.

1.5..Variable bet amount

Allow the user to change how much they would like to bet and change the amount you win accordingly. Allow bets between £1 and 4£ (integers only)

1.6.High score table

Create a high score table. The more money you have remaining in your bank at the end of the game the higher up the table you will be. In order to implement this, players will have to enter their name before they play. The high score table should be displayed as a separate message box after the results have been displayed at the end of the game(1.4)

Not1: Please use JoptionPane class instead of scanner class.

Not2: Also If possible explain the description of your classes: what each does and how they relate to each other. And if possible, program should be extensible. E.g. Is it easy to change the number of dice? The number of rounds to play? The sides of the dice?Etc.

OC4135869

CS100 Study Guide - Final Guide: Cable Modem, Electromagnet, Radiography

Document Summary

Get access

Related Documents

CS100 Lecture Notes - Lecture 7: Media Access Control, Cable Modem, Mac Address

CS100 Lecture Notes - Lecture 2: Digital Subscriber Line, Physical Layer, Communications Protocol

CS100 Chapter Notes - Chapter 5: Cable Modem, Unique Identifier, Dynamic Host Configuration Protocol

Related Questions