EG-UY 1003 Lecture Notes - Lecture 3: Tasmania, Reverse Engineering
9 Aug 2016
School
Department
Course
Professor
Document Summary
Lab 03: product evaluation and quality improvement (yellow) The experimental objective of this lab is to build and then reverse engineer the design of a robot that meets minimum standards for accuracy and precision. If the standards of certain companies are not met, then the robot is sent back for quality improvement and evaluation. However, if the standards are met, the product would be acceptably marketable. Each team builds a robot from scratch by using an ev3 robotics kit supplied by the eg. This design will be tested multiple times and run through the use of mindstorms software. The values needed to be calculated are the percent accuracy and percent precision. The minimum standards for passing the product into the market is 80% accuracy and precision. During the experimental evaluation, a standard distance and angle of deviation must be determined before proceeding to the tests. The average distance traveled and angle of deviation,
