PHY 102 Lecture Notes - Lecture 4: Angular Frequency, The Joshua Files

55 views4 pages

brownfly906

4 Feb 2017

School

Department

Course

Professor

For unlimited access to Class Notes, a Class+ subscription is required.

Document Summary

January 30, 2017 lecture 4 - everything about waves. Represents any physical process that propagates periodically or exhibits periodicity. Move side to side: transverse waves. Equal to the inverse of period (t) Measured in hertz (hz) f = 1/t. Amplitude = a = maximum displacement of any particle from its equilibrium. For a sinusoidal wave traveling in x-direction, amplitude is the maximum displacement in positive/negative y-direction. Wavelength = = velocity of a wave = = vt. Special type of waves (sin or cosine) Every point in string moves in shm with same amplitude and angular frequency: different max displacements at different times. Maximum speed = vm = a: angular frequency times amplitude. Maximum acceleration = am = 2a: (angular frequency)2 times amplitude. Interference: waves meet while traveling through the same mediums. In-phase: the maxima/minima (crest/troughs) occur at the same time. New amplitude is the sum of the separate amplitudes: amplitude = a1 + a2.

Related Questions

Good Vibes: Introduction to Oscillations

The conditions that lead to simple harmonic motion are as follows:

There must be a position of stable equilibrium.

There must be a restoring force acting on the oscillating object. The direction of this force must always point toward the equilibrium, and its magnitude must be directly proportional to the magnitude of the object's displacement from its equilibrium position. Mathematically, the restoring force F⃗ is given by ⃗, where is the displacement from equilibrium and k is a constant that depends on the properties of the oscillating system.

The resistive forces in the system must be reasonably small.

Consider a block of mass m attached to a spring with force constant k, as shown in the figure(Figure 1) . The spring can be either stretched or compressed. The block slides on a frictionless horizontal surface, as shown. When the spring is relaxed, the block is located at x=0. If the block is pulled to the right a distance A and then released, A will be the amplitude of the resulting oscillations.

Assume that the mechanical energy of the block-spring system remains unchanged in the subsequent motion of the block.

Part A

After the block is released from x=A, it will

(a) remain at rest

(b) move to the left until it reaches equilibrium and stop there.

(d) move to the left until it reaches x=−A and then begin to move to the right.

The time it takes the block to complete one cycle is called the period. Usually, the period is denoted T and is measured in seconds.

The frequency, denoted f, is the number of cycles that are completed per unit of time: f=1/T. In SI units, f is measured in inverse seconds, or hertz (Hz).

Part B

If the period is doubled, the frequency is

(a) unchanged

(b) doubled

Part C

An oscillating object takes 0.10 s to complete one cycle; that is, its period is 0.10 s. What is its frequency f?

Express your answer in hertz.

Part D

If the frequency is 40 Hz, what is the period T?

Express your answer in seconds.

The following questions refer to the figure (Figure 2) that graphically depicts the oscillations of the block on the spring.

Note that the vertical axis represents the x-coordinate of the oscillating object, and the horizontal axis represents time.

Part E

Which points on the x-axis are located at a distance A from the equilibrium position?

(a) R only

(b) Q only

Part F

Suppose that the period is T. Which of the following points on the t-axis are separated by the time interval T?

(a) K and L

(b) K and M

(d) L and N

(e) M and P

Now assume for the remaining Parts G - J, that the x coordinate of point R is 0.12 m and the t coordinate of point K is 0.0050 s.

Part G

What is the period T?

Express your answer in seconds.

Part H

How much time t does the block take to travel from the point of maximum displacement to the opposite point of maximum displacement?

Express your answer in seconds.

Part I

What distance d does the object cover during one period of oscillation?

Express your answer in meters.

Part J

What distance d does the object cover between the moments labeled K and N on the graph?

Express your answer in meters.

emeraldyak680

PHY 102 Lecture Notes - Lecture 4: Angular Frequency, The Joshua Files

Document Summary

Get access

Related textbook solutions

Physics: Principles with Applications

Related Documents

PHYSICS 1E03 Chapter Notes - Chapter 16: Transverse Wave, Longitudinal Wave, Wavenumber

PHYS 1C Chapter Notes - Chapter 13: Transverse Wave, Equilibrium Point

PHY 205 Lecture Notes - Lecture 23: Wavelength, Sound

Related Questions