L07 Chem 151 Lecture Notes - Lecture 3: Approximation Error, Sulfuric Acid, Volumetric Flask

14 views2 pages

salmonyak403

8 Feb 2016

School

WUSTL

Department

University College - Chemistry

Course

L07 Chem 151

Professor

Redden

For unlimited access to Class Notes, a Class+ subscription is required.

Document Summary

The % ag measured in 3 trials are 16. 34%, 16. 38%, 16. 17%, and 16. 35%. 16. 17% value be rejected from calculating the average. Calculate the gap : difference between the outlier and the closest value to it. If q is greater than the table value for q, then it can be rejected. Find the average and standard deviation of both sets of data. If the lowest possible value of the higher value and the highest value of the lower value has overlap, then it is possible. Molality = moles/mass ex) density of a 40. 0% by mass h2so4 solution is 1. 38 g/ml. Calculate: a) molality, b) molarity of this solution: molality of h2so4 = moles of h2so4/ (mass of water in kilogram) Mass of h2so4 = 40. 0g -> 0. 408 mol. Mass of water = 60. 0g -> 0. 0600 kg. molality of h2so4 = 0. 408 mol/0. 0600 kg = 6. 80 m b) molarity of h2so4 = moles of h2so4/(volume of solution in l)

Related Questions

Using this information: I used 4.00 g potassium dichromate. The amount of Iron ll is 4.00 gram in 2nd flask. Used grey moose vodka 2.00 ml and filled flask with water. This was the 2% vodka solution. For the experiment I used 5.00ml of the vodka and added 35.00 ml of more water to make it 1/8 of 2% or 0.25% of the original. With this information and the answer's i have placed in the table please help with remainder of questions. Need to work to understand answers so I will get correct on upcoming test. Thanks.

Calculate the concentration of the dichromate ion in the first volumetric flask.

Calculate the concentration of the iron (II) ion in the second volumetric flask.

Experiment 2: Titrate the Vodka Sample

Lab Results

Record the following lab data in the table below. If you had to repeat one of the titrations, disregard the value that was different.

(a) volume of potassium dichromate solution added to the Erlenmeyer flask in mL	5.00ml
(b) coarse titration volume of iron (II) solution range in mL	14.10 -14.15 ml
(c) volume of iron (II) solution delivered from the burette in mL during the first fine titration	14.13ml
(d) volume of iron (II) solution delivered from the burette in mL during the second fine titration	14.11ml
(e) average volume of iron (II) solution used in the fine titrations	14.12ml
(f) the color of the analyte solution at the end point of the titration	purple
(g) the color of the analyte solution after adding the indicator	dark green

Data Analysis

Record and calculate the quantities in the table below using the data from your dichromate titrations. Use an average value for the volume of iron (II) solution used in the titration. If one of your values is very different, and you had to perform the titration three times, disregard the value that was very different when computing the average.

(a) volume of potassium dichromate solution added to the Erlenmeyer flask in mL 5.00ml
(b) moles of dichromate ion added to the Erlenmeyer flask
(c) average volume of iron (II) solution delivered from the burette in mL 14.12ml
(d) moles of iron (II) ions delivered from the burette
(e) moles of excess dichromate ions that reacted with the iron (II) ions (remember that the ratio in which they react is 1 dichromate : 6 iron (II))
(f) moles of dichromate that reacted with the ethanol in the vodka (Subtract excess dichromate ions that reacted with the iron (II) ions from the original moles of dichromate ion present.)
(g) moles of ethanol in the 5 mL diluted vodka sample according to the stoichiometric ratio of 2 dichromate ions to 3 ethanol molecules

The amount of alcohol in a drink is typically reported as percent alcohol by volume. Volume percent or volume/volume percent (% v/v) most often is used when preparing solutions of liquids. Volume percent is defined as:
% v/v = V_solute/V_solution Ã 100
Find the percent alcohol (ethanol) by volume for the vodka used in the lab by following the steps outlined in the table below.

(a) given the molar mass of ethanol of 46.07 g/mol, calculate the mass of alcohol (ethanol) in the tested sample solution
(b) given the density of ethanol of 0.7893g/ml, find the volume in mL of ethanol present in the diluted vodka solution
(c) record the volume of vodka used in the experiment in mL
(d) find the percent alcohol by volume (% v/v) in the diluted vodka solution
(e) the diluted vodka solution was prepared by diluting 2.00 mL vodka to 100.00 mL. Calculate the dilution factor used (N:1)
(f) multiply the percent alcohol by volume in the diluted vodka solution by the dilution factor to obtain the % v/v alcohol in the original vodka solution

Conclusions

The Grey Moose vodka tested in this lab reports a percent alcohol by volume of 40.0% on its label. How does your value compare to the reported one? If the values are different, give one possible experimental error that might have contributed to the difference.

Potassium permanganate is another strong oxidizing substance similar to potassium dichromate. An acidic solution of purple permanganate ions can get reduced to colorless Mn²⁺ ions in the presence of ethanol. Write down the redox reaction between permanganate and ethanol, and balance it using the half-reaction method.

Besides vodka, there are other colorless alcohol-containing beverages that can be titrated following the procedure in your lab. Given the average values for the percent alcohol by volume listed in the table below, which beverage do you expect to use the least amount of iron (II) standard solution during the titration? Assume all lab procedures stay the same.

	% alcohol by volume
White rum	37.0%
Vermouth	18.0%
White whine	12.0%

L07 Chem 151 Lecture Notes - Lecture 3: Approximation Error, Sulfuric Acid, Volumetric Flask

Document Summary

Get access

Related textbook solutions

Chemistry: Structure and Properties

Basic Chemistry

Principles of Chemistry Molecular Approach

Principles of Chemistry Molecular Approach

Chemistry: Structure and Properties

Chemistry: A Molecular Approach

Chemistry: A Molecular Approach

Principles of Chemistry: A Molecular Approach

Chemistry: The Central Science

Related Documents

L07 Chem 151 Lecture Notes - Lecture 23: Molar Concentration, Volumetric Flask, Stopcock

CHE-1102 Lecture Notes - Lecture 3: Colligative Properties, Mole Fraction, Molar Mass

CHEM 1101 Lecture Notes - Lecture 4: Graduated Cylinder

Related Questions