COMP1002 Lecture Notes - Polygonal Chain, Cad Standards, Architectural Drawing
Document Summary
Describe the various commands used in drawing a circle. There are 6 different options to draw the circle which are in the following: (i) Then select the center of the circle and then put the numerical value of circle radius and press enter button. (ii) You first select the center radius circle drawing option. Then select the center of the circle and then put the numerical value of circle diameter and press enter button. (iii) This option is used if want to draw a circle that passing through any two points. This option is used if want to draw a circle that passing through or toughing any three points. (v) When there is need to draw a circle at which two already drawn lines are tangent and also needed the value of circle radius, then we use this option. After selecting this option first we select the first line and then select second line.
