A large tower is to be supported by a series of steel wires; it is estimated that the load on each wire will be 1.35x10^4 N. Determine the minimum wire diameter (in mm) to avoid yield. Assume a factor of safety of 2 and a yield strength of 860 MPa for the steel.

answers

watching

views

For unlimited access to Homework Help, a Homework+ subscription is required.

Related questions

A cylindrical rod has an undeformed length of 95 mm and an undeformed diameter of 25.0 mm. A tensile force of 9.9x10^4 N is applied along the axis of the rod. Calculate the minimum yield strength (in units of MPa) needed to avoid plastic deformation. Assume a factor of safety of 3

A steel telephone wire 125 m long and 1 mm in radius isstretched to 125.15 m by an
applied force of 800 N. (The weight of the cable may beignored.)

a. What is the elastic modulus of steel ?
b. What is the maximum force that can be applied to the wire,without it breaking?
c. How long will the wire be in part (b) ?
d. How thick will the wire be when 1200 N is applied ?

Assume a Tensile Strength of 500000000 Pa

and Poissonâs ratio of0.28 for steel

Link AC is made of steel with 65-ksi ultimate normal stress and has a 1/4 x ½ inch. uniform

rectangular cross-section. It is connected to a support at A and to member BCD at C by 3/8 inch

diameter pins, while member BCD is connected to its support at B by a 5/16 inch. diameter pin.

All of the pins are made of steel with a 25-ksi ultimate shearing stress and are in single shear.

Given a factor of safety of 3.25, determine the largest load P that can be applied at D. Note that

link AC is not reinforced around the pin holes. (1 ksi = 1000 psi)