Study Guides (390,000)
CA (150,000)
McGill (6,000)
EPSC (40)
Final

EPSC 201 Study Guide - Final Guide: Industrial Revolution, Liquidus, Magma Chamber


Department
Earth & Planetary Sciences
Course Code
EPSC 201
Professor
Anthony Williams- Jones
Study Guide
Final

This preview shows page 1. to view the full 5 pages of the document.
EPSC201 2006 Final Exam Review Section 3&4
1) The San Andreas Fault is a transform fault. Explain this statement.
In the new idea, the relative position of the two ridges remains unchanged, but the continents (green)
move further apart. In the old idea, the ridge and continents both move relative to each other.
It is easier to move continents apart if the drift is due to many small slips, instead of one big slip.
The main message is that the only movement occurring is in-between the ridges, because outside of the
ridges, the crust is moving in the same direction at the same speed.
Key Assumption – the top and bottom ridges are spreading at exactly the same rate
2) Describe the most important properties of diamond and graphite (one for each
mineral) and relate these properties to molecular structure.
We started talking about diamonds last class; are purely carbon. Every carbon atom is bonding to every
other carbon atom. They are short and strong bonds (homogenous), which results in a super hard
structure. When we say it’s hard, it’s not that we cannot break it with a hammer (we will smash it), what it
means is that it cannot scratch easily.
What makes diamond super strong is the fact that the carbons are covalently bonded which makes it
super hard.
Diamonds are ONLY formed under high temperature and high pressure (need depth of at 150-200km). If
diamonds were formed on shallow depths, it would be graphite instead and not diamond. Diamonds reach
the surface of the earth through volcanos; specifically magma liquid breaking pieces of rocks/mantle as it
shoots up through the earth.
Graphite is made up of purely carbon atoms as well, but in a layered sheet (plane) formation through
covalent bonding. The atomic arrangement is the same as in diamond, but the plane sheets are held
together weakly by Van der Waal’s bonding.
Graphite and diamonds are not forever. But the amount of energy it takes to convert diamonds to graphite
is extraordinarily high and it will take a few hundred/thousands of years before it becomes graphite.
However, if you put diamond in the oven, it will fuse with oxygen and produce carbon dioxide.
3) Describe the molecular structure of pyroxene and explain its bonding.
Pyroxene: two types (Diopside or Hypersthene)
Pyroxene are chains of silicate tetrahedron
glued together by cations through ionic bonds.
Key Point is to understand how chain silicate
tetrahedrons need cations to balance the charge
in order to form neutral structures.
Silicate Structures
Inosilicate Inosilicate
(Single chain)
Sheet silicate
Nesosilicate
(Double chain)
Framework silicate
SiO44 -
SiO32-
Si4O104 - SiO2
Si4O116 -
You're Reading a Preview

Unlock to view full version

Only page 1 are available for preview. Some parts have been intentionally blurred.

4) Using a sketch, describe and explain the Rock Cycle.
Igneous rocks are at the beginning of the
cycle. These rocks weather and compact into
sedimentary rocks. If this sedimentary rock
are heated and buried deep enough, they
turn into metamorphic rock. If the
metamorphic rock is buried deep enough, it
melts into magma, and will later form into
igneous rocks.
5) Describe typical strato- and shield volcanoes and explain why they differ.
Volcanism is associated with spreading ridges. Iceland is a good example. Volcanoes are also
associated wit hot spots, such as Hawaii. Volcanoes are forming from magma that is subjected from
decompression melting. Upwelling of mantle (plume) causes melting, which in turn causes a volcano.
The magma has a very low viscosity, meaning it flows easily. These volcanoes are termed shield
volcanoes, which have very subtle hills because the lava flows far out from the crater. The lava is made
of basalt in these types of volcanoes. At low silica content, the lava is made of isolated tetrahedrons.
This flows easier then lavas made of complex silicate mixtures.
Stratovolcanoes – carbonate lavas (baking soda – bicarbonates), these magmas have high silica
content, which increases its explosive activity.
You're Reading a Preview

Unlock to view full version