Geography 2011A/B Final: Review Notes for Exam #2- Geography 2011.docx

163 views35 pages

aquamarineox222

14 Apr 2012

School

Department

Course

Professor

For unlimited access to Study Guides, a Grade+ subscription is required.

Document Summary

Notes for: institutions and rules for the environment of the great lakes. Remedial action plans (raps), are designed with an ecosystem principle in mind. Early studies in canada focused on point source regulations and rules of national governments. Boundary waters treaty, 1909: established after american revolution, split jurisdiction over the lakes but retained exclusive british jurisdiction over the lower st. lawrence. Ijc consisted of six commissioners, three appointed by the president of the. Two rivers are to be considered one and shared equally between the two countries: also has power to arbitrate between two countries, but has never been exercised (gov"ts prefer to resort to conventions) The commission has been created to serve the canadian and the united. States governments by assisting them in avoiding and resolving contentious or potentially difficult issues. The commission fulfills this role by responding to references and by deciding on applications for approval to use, obstruct or divert boundary waters and transboundary rivers .

Related Questions

Good Vibes: Introduction to Oscillations

The conditions that lead to simple harmonic motion are as follows:

There must be a position of stable equilibrium.

There must be a restoring force acting on the oscillating object. The direction of this force must always point toward the equilibrium, and its magnitude must be directly proportional to the magnitude of the object's displacement from its equilibrium position. Mathematically, the restoring force F⃗ is given by ⃗, where is the displacement from equilibrium and k is a constant that depends on the properties of the oscillating system.

The resistive forces in the system must be reasonably small.

Consider a block of mass m attached to a spring with force constant k, as shown in the figure(Figure 1) . The spring can be either stretched or compressed. The block slides on a frictionless horizontal surface, as shown. When the spring is relaxed, the block is located at x=0. If the block is pulled to the right a distance A and then released, A will be the amplitude of the resulting oscillations.

Assume that the mechanical energy of the block-spring system remains unchanged in the subsequent motion of the block.

Part A

After the block is released from x=A, it will

(a) remain at rest

(b) move to the left until it reaches equilibrium and stop there.

(d) move to the left until it reaches x=−A and then begin to move to the right.

The time it takes the block to complete one cycle is called the period. Usually, the period is denoted T and is measured in seconds.

The frequency, denoted f, is the number of cycles that are completed per unit of time: f=1/T. In SI units, f is measured in inverse seconds, or hertz (Hz).

Part B

If the period is doubled, the frequency is

(a) unchanged

(b) doubled

Part C

An oscillating object takes 0.10 s to complete one cycle; that is, its period is 0.10 s. What is its frequency f?

Express your answer in hertz.

Part D

If the frequency is 40 Hz, what is the period T?

Express your answer in seconds.

The following questions refer to the figure (Figure 2) that graphically depicts the oscillations of the block on the spring.

Note that the vertical axis represents the x-coordinate of the oscillating object, and the horizontal axis represents time.

Part E

Which points on the x-axis are located at a distance A from the equilibrium position?

(a) R only

(b) Q only

Part F

Suppose that the period is T. Which of the following points on the t-axis are separated by the time interval T?

(a) K and L

(b) K and M

(d) L and N

(e) M and P

Now assume for the remaining Parts G - J, that the x coordinate of point R is 0.12 m and the t coordinate of point K is 0.0050 s.

Part G

What is the period T?

Express your answer in seconds.

Part H

How much time t does the block take to travel from the point of maximum displacement to the opposite point of maximum displacement?

Express your answer in seconds.

Part I

What distance d does the object cover during one period of oscillation?

Express your answer in meters.

Part J

What distance d does the object cover between the moments labeled K and N on the graph?

Express your answer in meters.

emeraldyak680

3. 3 Stratosphere-troposphere exchange

The rate of exchange of air between the troposphere and thestratosphere is critical for determining the potential of variouspollutants emitted from the surface to reach the stratosphere andaffect the stratospheric ozone layer. One of the first estimates ofthis rate was made in the 1960s using measurements of strontium-90(90Sr) in the stratosphere. Strontium-90 is a radioactive isotope(half-life 28 years) produced in nuclear explosions. It has nonatural sources. Large amounts of 90Sr were injected into thestratosphere in the 1950s by above-ground nuclear tests. Thesetests were banned by international treaty in 1962. Following thetest ban the stratospheric concentrations of 90Sr began to decreaseas 90Sr was transferred to the troposphere. In the troposphere,90Sr is removed by wet deposition with a lifetime of 10 days (bycontrast there is no rain, and hence no wet deposition, in thestratosphere). An intensive stratospheric measurement network wasoperated in the 1960s to monitor the decay of 90Sr in thestratosphere. We interpret these observations here using a 2-boxmodel for stratosphere-troposphere exchange with transfer rateconstants kTS and kST (yr-1) between the tropospheric andstratospheric reservoirs. The reservoirs are assumed to beindividually well-mixed.

Let mS and mT represent the masses of 90Sr in the stratosphere andin the troposphere respectively. Observations of the decrease inthe stratospheric inventory for the period 1963-1967 can be fittedto an exponential mS(t) = mS(0)exp(-kt) where k = 0.77 yr-1.

1. Write mass balance equations for mS and mT in the 1963-1967period.

2. Assuming that transfer of 90Sr from the troposphere to thestratosphere is negligible (we will verify this assumption later),show that the residence time of air in the stratosphere is tS =1/kST = 1.3 years.

3. Let m'T and m'S represent the total masses of air in thetroposphere and the stratosphere, respectively. Show that theresidence time of air in the troposphere is tT = tS (m'T/m'S) = 7.4years. Conclude as to the validity of your assumption in question2.

4. Hydrochlorofluorocarbons (HCFCs) have been adopted asreplacement products for the chlorofluorocarbons (CFCs), which werebanned by the Montreal protocol because of their harmful effect onthe ozone layer. In contrast to the CFCs, the HCFCs can be oxidizedin the troposphere, and the oxidation products washed out byprecipitation, so that most of the HCFCs do not penetrate into thestratosphere to destroy ozone. Two common HCFCs have trade namesHCFC-123 and HCFC-124; their lifetimes against oxidation in thetroposphere are 1.4 years and 5.9 years, respectively. There are noother sinks for these species in the troposphere. Using our 2-boxmodel, determine what fractions of the emitted HCFC-123 andHCFC-124 penetrate the stratosphere.

Vapor cycles
5EM - Thermodynamics
September 2010
1 The T-S diagram
The temperature-entropy diagram is an alternative to the well knownpressure-
volume diagram. Before using it to analyze different vapor cycles,we need
to understand it properly.
1. Plot the following transformations for ideal gases in a T-Sdiagram
(a) Isothermal expansion
(b) Isobaric expansion
(c) Isometric heating
(d) Reversible adiabatic expansion
(e) Irreversible adiabatic expansion
2. Repeat the last question, but this time do it for a realsubstance,
starting in the compressed liquid1 region and ending in thesuperheated
region, when possible. Indicate the boundaries of eachregion.
3. We know that under certain circumstances the area under theplot
in a P-V diagram represents the work performed during theprocess.
What does it represent in this case? Under what assumptions isyour
answer true? Compare examples 6.1 and 6.2.
2 Thermal machines
We understand by thermal machine a device capable of transformingther-
mal energy (heat) into mechanical energy (work). We already knowthat
these machines have a limited efficiency which, in the two-sourcesmodel, is
obtained by Carnotâs cycle.
(Compressed liquid is sometimes also called subcooled liquid)
2.1 Carnot cycle
This cycle, although efficient, is impractical. To begin with, theextreme
temperatures of the cycle should be within the sources temperaturesfor a
finite heat flow to exist.
1. Given the temperature of the sources, draw the cycle accordingto the
named limitation.
2. Show that this leads to lower efficiency than the theoreticallimit.
3. Assume that heat flow from/to the sources is proportional to thetem-
perature difference between them and the working fluid, anddemon-
strate that a higher power output is related to a decreasedefficiency.
2.2 Rankine cycle
Out of the several practical possibilities, Rankine cycle and itsvariations is
widely used, especially for electric power generation.
1. Draw the basic cycle in a T-S diagram and explain it.
2. What does the efficiency of the cycle depend on? Comparewith
Carnotâs.
3. What are the differences between the ideal cycle and the realone?
4. Describe how it is modified by superheating and/or reheating.Explain
te benefits.
2.3 Problems
After answering the previous questions solve the followingexercises from the
book: 8.2, 8.4, 8.5, 8.13, 8.19, 8.20
3 Frigorific machines
3.1 Reverse Carnot cycle
We have already studied Carnot cycle in detail as the ideal thermalmachine.
Now we will take is as the starting point to understand thecharacteristics
of frigorific machines.
1. Draw the ideal cycle in a T-S diagram and explain it.
2. Show that this cycle has a theoretical efficiency Ã =Tcold/Thot-Tcold
3. What are the difficulties in implementing such cycle in actualdevices?
3.2 Actual refrigerators
1. Why is the turbine replaced by an expansion valve in mostcases?
2. Plot the actual cycle and explain the differences with the idealcase.
3. How do cascade and multistage systems improve the performanceof
the refrigerator?
4. What aspects are important in the choice of a refrigerant fluid?Justify
3.3 Problems
After answering the previous questions solve the followingexercises from the
book: 10.2 10.7, 10.8, 10.9, 10.22, 10.23 10.1D

Geography 2011A/B Final: Review Notes for Exam #2- Geography 2011.docx

Document Summary

Get access

Related Documents

Geography 2011A/B : Keeping Remedial Action Plans on Target.docx

Geography 2011A/B Lecture Notes - Lecture 11: Great Lakes Areas Of Concern, International Joint Commission, Treaty 6

Geography 2011A/B Lecture Notes - Lecture 3: Great Lakes Basin, International Joint Commission, United States Environmental Protection Agency

Related Questions