Log in
Mechanical Engineering
7
answers
1
watching
276
views

A spur pinion rotates at 1800 rpm and transmits to a mating gear 30 HP. The pitch diameter is 4” and the pressure angles pressure angle is 14 1/2. Determine the tangential load in lbs.

Watch
7
answers
1
watching
276
views

For unlimited access to Homework Help, a Homework+ subscription is required.

Unlock all answers

Get 1 free homework help answer.
Already have an account? Log in
Share
Already have an account? Log in
Share
Already have an account? Log in
Share
Already have an account? Log in
Share
Already have an account? Log in
Share
Already have an account? Log in
Share
Already have an account? Log in
Share

Related questions

The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as shown above. Determine the gage pressure of air in the tank.

If

=0.2 m, =0.3m, and =0.46m.

Take the densities to be:

A sump pump is draining a flooded basement at the rate of 0.750 L/sec with an output pressure of . The water enters a hose with 3 cm inside diameter and rises 2.50 m above the pump. What is the pressure at this point?

6. A uniform beam AB of weight 1000N is pinned to a vertical wall and is held at an angle to the vertical by a rod BCof a circular cross-section, forming an angle of with the beam.
a) Determine the reaction of the pin A and the tension in the rod BC
b) Determine the diameter of the pin (double-shear) if the failure stress =400MPa and the safety factor S.F.= 2 ;
c) Determine the minimum diameter of the rod BC. The failure normal stress for the material of the rod is ơ =300MPa and S.F.=2

Related Documents

ME 371 Chapter Notes - Chapter 10: Fatigue Limit, Standard Deviation, Velocity Factor
cerisehamster618
MCG 3131 Lecture Notes - Lecture 14: Pressure Angle
copperporpoise343
MEC 430 Chapter Notes - Chapter 11: Pressure Angle, Hoboken Catalogue, Infor
greygoat24

Weekly leaderboard

Home
Homework Help 3,900,000
Mechanical Engineering 400
Start filling in the gaps now
Log in